Lexus IS300 01-05 Steering Column Cover Triple Gauge Pod

Description

This 3D printed part goes on the steering column cover. Designed to fit a 52mm or 2 1/16 gauge with a depth of 2.5 inches. I designed this so no matter what gauge style you choose you can see as much of the cluster as possible, tilt the steering wheel up down and use the turn signal. Each gauge pod is pointed straight forward and directly in the drivers peripheral vision. This fits on the front half of the steering column cover and every design follows the contours of the steering column cover for a clean look. This will work on any IS300 01-05, manual or automatic, sedan or sportcross.
If this design does not work for you I have many other styles in my store.
This listing is only for the 3D printed part. It doesn't come with the gauges or any interior trim.
I have many other designs for the IS300. If you don't like this one take a look at some of my other designs.
Installation is simple. You remove the cluster trim and the steering column cover and drill holes in the steering column cover with the supplied template. Each gauge pod is held in place by two bolts that go through the steering column cover. I recommend using M4x10 bolts,M4 nut and a washer for proper fitment. Once installed you can't see any of the hardware. Every pod comes with a drill template for proper placement. I designed these with an autometer 52mm gauge which is actually 52.4. If your gauge is too loose add a layer of tape around it until it fits, too tight sand until it fits.
Made out of ABS plastic the same material most of the interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.
This item can be made with depths of 2", 2.5" or 3". Please send me a message once you purchase this for the depth you want. If you don't contact me you will receive a 2.5" depth gauge.